Navigate to the Ethernet/FTP settings screen on the CNC control.
Fill out settings as follows:
| Host Name | |
|
Use DHCP |
0 |
| IP Address | {{Your Desired IP}} |
| Mask Bit | 255.255.255.0 |
| Default Gateway | |
| Auto acquisition of DNS server addr | 0 |
| DNS server address 1 | |
| DNS server address 2 | |
| Port No. | 10000 |
Connect an ethernet line from your main network to the machine. Restarting the machine may be required.
Verify machine connection by pinging from another device on the network
PC
Open Start > Command Prompt
Enter the "ping" command followed by your machine's IP address: ping Machine_IP_Here and press enter
If all is well, you'll receive a few messages saying "Reply from" as shown below.
Mac
Open Terminal
Enter the "ping" command followed by your machine's IP address: ping Machine_IP_Here and press enter
If all is well, you'll receive a few messages saying "64 bytes from" as shown below.
Comments
0 comments
Article is closed for comments.